#SCRAP MECHANICS SUPER CHOPPY DOWNLOAD#

It’s marketed as “the new game by the guys who did Left 4 Dead” (though realistically it’s more like “by a team whose leads were in the L4D team”). So I was wondering – is there a direct corellation between how, er, „gamey” the game is and how difficult it is to sell it? As in: maybe we don’t have good methods to present the essence of games through their natural enviroment, so instead we are focusing on the visual aspects: cutscenes, elaborated animations and such (kinda like advertising books just by their covers)? If so, what can we do to make gamey games and be filthy rich at the same time? I don’t think their awesomeness can be captured in one picture or 5-seconds long video. Which is great – I think Prey is a perfect example of what video games should be if they’re to have their own language – but showing that to the mass audience in order to sell it could be hard. And it seems to me that, generally speaking, selling these types of titles might be difficult – their strength lies in the way they allow players to use the game’s environment and mechanics to achieve their goals (I think it’s called „emergent gameplay”?). Valheim does look really nice.Ĭouple of months ago I played Prey (2017). Looks like Paul had a better week than I did. I’d really love this game if it wasn’t for the small number of flaws that make me HATE it.

#SCRAP MECHANICS SUPER CHOPPY DOWNLOAD#

There are other ways to remove or de-lagify bearings, but these are the main ones I tend to use, let me know if there is anything else I should know about removing bearings.Direct download (MP3) Direct download (ogg Vorbis) Podcast RSS feed. To make one use a medium pipe going through a 1-block hole, no junction bearings needed, but this can make a shaft a little more wobbly if there is any unbalances.

If you still need to remove more bearings, you can just use a bracket. One solution is to use only 1 bearing on the output side and to use a counterweight to prevent wobbling.

This design works just fine, but when there is a lot of resistance, speed, and torque involved, it starts to wobble, cause lag, and make noise. Lastly, if you need to make a junction for a shaft in for example a piston engine, the most common one you will see is this one:

It also means that when the load is pushed off the bearing and starts fly all over the place, since it weighs so much and is too far from the bearing, it will keep flying because it can't stop at the bearing! So keep bearings/pistons/suspensions under as little load as possible. Putting the load farther from the bearing gives it more power over the bearing, making the bearing weaker when connected to an engine and worse. You can't see it in the picture, but bearings/pistons/suspensions start to bend once they have a large load on them. Īnd if you really need to cut down on bearings, try a monowheel, but if you use this, you will need to have a low center of mass and a wide wheelframe.Īnother important note, try to keep the load as close to the bearing (or suspension or piston) as possible, or the bearing as close to the load. Even if you can only remove 1 or 2 in one spot, do it.įor example, if you're not going for style, try using a central steering bar. Here are some tips to be reducing bearings and being safer with bearings.įirst, if you've got 50 bearings on your creation, try to remove as many as possible.

Scrap mechanics super choppy